Re: Stuck bRAS profiles..


So what gives? What's the real answer here?

For what it's worth I've found that a DMT capable
modem helps a lot. You can set your target SNR and
your BRAS profile should follow. If there are any errors
at all then your profile tends to be stuck, lower your
target SNR with DMT and your speed jumps, it
will however fall again if you set the target SNR to
too low a value, or try to change it too often.
But used with caution DMT tool will get you a better
speed and profile than sitting back and waiting for
something to happen.
I've used an ADSL only modem with long line flash,
two DMT capable modems, and the highly recommended
2 wire. The DMT capable gave the best sustainable
speeds.
.

Relevant Pages

  • Re: Disparity in available speeds
    ... As I think I've mentioned before George, this tool doesn't take into account your target SNR. ... "Rate adaptive DSL also makes use of any spare SNR Margin therefore the higher your SNR Margin, then the better your speeds will be. ... Therefore if you have a higher/lower target SNR set on the DSLAM then this will affect your maximum speed." ... IP Profile: 6500kbps ...
    (uk.telecom.broadband)
  • Re: Please recommend a desktop system for me, a programmer, for < $1k
    ... The "profile" is a cap inserted at the ISP end, ... or signal to noise ratio. ... DMT reads out the information inside the modem. ... to your ISP, they can adjust the profile to suit the situation. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Please recommend a desktop system for me, a programmer, for < $1k
    ... The "profile" is a cap inserted at the ISP end, ... or signal to noise ratio. ... DMT reads out the information inside the modem. ... to your ISP, they can adjust the profile to suit the situation. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: WinXP default fax software no longer works
    ... The problem arises because initializing strings are written to the modem which are not removed by the uninstall procedure. ... Typically, there may be 2 such profiles, in addition to a hard-coded factory profile. ... Assuming that the modem uses the Hayes-compatible AT command set, one can view and modify these initialization strings using an application that directly addresses the modem, such as HyperTerminal. ...
    (microsoft.public.windowsxp.print_fax)
  • Re: Camera phone help needed.
    ... >> to add this to the great equation of life, the universe, and everything: ... >MPT and go through the "new modem" setup in it to the point where it ... >will turn on the DUN profile, but I don't think that it is ...
    (alt.cellular.verizon)