Re: Router synch rate & IP profile



Kit wrote:

In article <atcfzvasbuvgflfgrzfygqhx.jpk2ds1.pminews@ouse>, Rodney Pont
<aspaminy7@xxxxxxxxxxxxxxxxxxxxx> wrote:

A sync rate of 7313 should give an IP rate of about 6.5 meg according
to the table here http://aaisp.net.uk/maxatm.html (bottom of page) but
you would need to have been above 7392 for a few days for that to
happen and to never drop below. Since you are only getting 5269 kbps,
probably due to contention further up the line, it's unlikely to make
any difference to you anyway. Does your modem have any logs so that you
can see if the sync rate for your connection changes?

You will get the best rate by splitting out your ADSL from the phone
line at the master socket and sending just phone signals to any
extensions or even using better filters if you have cheap ones. That's
an entirely different bag of worms that you may not want to open though
:-)

I'm assuming you are on MAX via BT, if you are on someones LLU they may
well have their own rates and rules.

Hi,

Thanks for the response.

The BT speed test I quoted was just the one I got that morning. The
average speed I get is a bit over 5,500 and the max is just under
6,000. I'm not really complaining about speed (it is good enough for
me) but was just trying to understand all the different numbers - e.g.
is the IP profile number before or after 'overheads'.

The router is plugged directly into the master socket ADSL faceplate
installed by BT and there is only one phone plugged into it and no
extensions. AFAIK my router (an old speedtouch pro) doesn't have a log.
I am on BT Max with Entanet (UKFSN as reseller).

The IP profile is 'what you get' to your PC. The overheads have already been
deducted.

Graham

.

Relevant Pages

  • Re: Router synch rate & IP profile
    ... extensions or even using better filters if you have cheap ones. ... The router is plugged directly into the master socket ADSL faceplate ... AFAIK my router doesn't have a log. ...
    (uk.telecom.broadband)
  • Re: Loss of Synchronization Problem
    ... master socket and where ever,. ... router, changed the filter for a new one, plugged direct into the master ... router directly into the master socket and still the router will not ... I have a similar problem with house extensions - the extensions are either ...
    (uk.telecom.broadband)
  • Re: Slow speed on BT Broadband
    ... line is that direct connection to BT master socket with all phones ... and router direct to main socket ... connect the router to the master socket and leave it there. ...
    (uk.telecom.broadband)
  • Re: Line dropping out after 10-15 seconds
    ... routers plugged in they said the stats showed I live about 1km to my ... BT suggested that I tell my ISP to escalate the ... The Be Box router produces a short pulse of noise that's audible on ... If you have a modern master socket you can try the tests ...
    (uk.telecom.broadband)
  • Help re noisy Bt line
    ... I have a Bt line which supply our ADSL line and my ISP is Sky max. ... I have three extesnions coming off my Bt master socket and one of those is ... For good measure I also disconnected wire 4 as this is not ... I have looked at the wires used in the extensions and its reasonable quality ...
    (uk.telecom.broadband)