Re: hydraulic /pneumatic cylinders

On 30 May, 19:10, "TT_Man" <Some...@xxxxxxxxxxxx> wrote:
can anyone point me in the right direction?.... I want to make a couple of
small ones, running 8-10 bar max to operate the undercarriage on an RC
'plane. Are there any designs around? Size needs to be approx. 20mm bore,
50mm stroke, double acting, single rod.

That`s a bog standard cylinder.You would buy one far cheaper than
making it.Look on Ebay or try SMC

.

Relevant Pages

  • Re: hydraulic /pneumatic cylinders
    ... 'plane. ... Are there any designs around? ... Size needs to be approx. ... 20mm bore, ...
    (uk.rec.models.engineering)
  • Re: Alternative to glow fuel
    ... What size should I make the camera plane? ... one set of wings, and then build a longer set if you want it later. ... designs, where the bottom is flat to the spar and then curves up to the ... I found that there is no reason not to use flat bottomed wings ...
    (rec.models.rc.air)
  • Re: Aircraft cannons vs. machineguns
    ... >>job, getting such into production! ... > to work out a specification for such a plane. ... > Manufacturers developed designs to meet the specification. ...
    (soc.history.war.world-war-ii)
  • Re: Alternative to glow fuel
    ... What size should I make the camera plane? ... one set of wings, and then build a longer set if you want it later. ... designs, where the bottom is flat to the spar and then curves up to the ... such as the aforementioned soda cans ...
    (rec.models.rc.air)
  • A500 and Cessna Skymaster
    ... a bit too expensive to operate as a low-income family plane. ... why don't ALL manufactures change their twins into the inline ... Do the inline designs cost more to build? ...
    (rec.aviation.student)