Re: rotary table recommendation

On Wed, 28 May 2008 14:32:03 +0100, Chris Edwards
<Mustardmender-one@xxxxxxxxxxx> wrote:



I'm still not sure what you're saying....I know you can bolt a
four-jaw directly to the face of the Vertex...but you can also fit a
four-jaw to a spigot fitted in the 2MT centre hole. I have a 4-jaw, with
a threaded Myford body, fitted at the moment.

I suspect that the problem with that is the very significant loss of rigidity.


Mark Rand
RTFM
.

Relevant Pages

  • Re: Changing Building Materials to Metric
    ... inches. ... It MUST fit the old pipe. ... being a real problem would be with liquid measurements. ... A 9/16 wrench will fit a 9/16 bolt the just as well as a 12 MM wrench ...
    (alt.home.repair)
  • Re: Odd sized Allen bolts?
    ... > key will be found in any decent set of keys. ... these would fit the bolt in question.It is between 2 and 3mm head size.I ... 3mm too big, imperial keys were similar. ...
    (uk.rec.cars.maintenance)
  • Lathe Steady Rest Construction Progress
    ... was find a scrap and make it fit widthwise, then tap it for the bolt. ... lathe and the piece is aluminum so I tapped it 1/2"-13 to fit a bolt I ... attach the pulley to the angle tomorrow. ...
    (rec.crafts.metalworking)
  • Re: [SLE] Warning to Americans!
    ... Why should a particular country change ... >>> another meant that nuts made, eg. here in Staffordshire would not fit ... >>> a bolt made in Warwickshire. ...
    (SuSE)
  • Re: Used Civic or new Fit?
    ... and improved mpg over the steel winter wheels. ... My Konig wheels have 4x100 bolt pattern. ... The 15 inch alloys on the Sport are 4 bolt. ... I wonder if Tire Rack has the Fit ...
    (rec.autos.makers.honda)