Re: rotary table recommendation

On May 26, 7:50 pm, lfoggy <lfoggy.3a1...@xxxxxxxxxxxx> wrote:
Hi,
I need a new 6 inch rotary table and have seen the Vertex offering at a
recent show. Also looking at one from Arc Eurotrade which is a bit
dearer but looks better made. Any experience with these ?
There's also the second hand option but ex-industrial ones all tend to
be too big for my needs.

--
lfoggy
------------------------------------------------------------------------
lfoggy's Profile:http://www.rcgroups.com/forums/member.php?u=103324
View this thread:http://www.rcgroups.com/forums/showthread.php?t=870056

Hi Ifoggy,
I have the Vertex and am happy with it, I also have the tail centre
and dividing attachment. The rub was after I bought all the bits they
were on offer as a set for very much less than I paid, boo hoo!
If you are going to buy a RT,check how many Tee slots it has, some
have three, some have four. If yoiu get a four one you can mount a
four jaw chuck, which comes in handy sometimes.
T.W..
.

Relevant Pages

  • rotary table recommendation
    ... I need a new 6 inch rotary table and have seen the Vertex offering at a ... Also looking at one from Arc Eurotrade which is a bit ... lfoggy's Profile: http://www.rcgroups.com/forums/member.php?u=103324 ...
    (uk.rec.models.engineering)
  • Re: rotary table recommendation
    ... I need a new 6 inch rotary table and have seen the Vertex offering at a ... Also looking at one from Arc Eurotrade which is a bit ... I've got the AET 6inch table, ... One simple mod was to add a thrust race. ...
    (uk.rec.models.engineering)