Re: Torx sizes
- From: Cheshire Steve <oldnoccer@xxxxxxxxxxxxxx>
- Date: Fri, 28 Sep 2007 12:58:08 -0700
On 28 Sep, 01:22, Graham <grahams...@xxxxxxxxxxxx> wrote:
On Thu, 27 Sep 2007 15:39:34 -0700, Cheshire Steve
<oldnoc...@xxxxxxxxxxxxxx> wrote:
I have found more horrible Torx cap head screws - big ones for which I
don't have a key. I don't understand the sizing - the biggest I have
in my set is T40 - which are 6.5mm across between points - so how the
heck are they sized ? 40 what, gnats crotchets ? I suppose I will have
to buy some more bits, but I need to measure these so I buy big
enough.
Ta, Steve
Can't help with why a T40 is a T40, but the following web page lists
all the point to point measurements with their corresponding T number:
http://www.wihatools.com/Marketing/torxspec.htm
Graham
Thanks Graham,
I had a good Google around, but I didn't find that one.
Steve
.
- References:
- Torx sizes
- From: Cheshire Steve
- Re: Torx sizes
- From: Graham
- Torx sizes
- Prev by Date: Re: Torx sizes
- Next by Date: Re: Hand taps with centring hole?
- Previous by thread: Re: Torx sizes
- Next by thread: Re: Torx sizes
- Index(es):
Relevant Pages
|
