Re: Cheap spindle speed method

Anzaniste wrote:

My method takes some beating for economy.  Take a length od studding
the longer the better. Stick it in the chuck. Put anut on it. Measure
and mark a length on the studding. Start the lathe. Grab the nut and
time it between the measured marks. ...

LOL! This method can't be beaten! In any field! :-))


Nick
.

Relevant Pages

  • Re: Cheap spindle speed method
    ... and mark a length on the studding. ... Start the lathe. ... Grab the nut and ...
    (uk.rec.models.engineering)
  • Re: Thread cutting on a reversible lathe
    ... If the latter, then you were probably cutting metric threads, and the ... cutting a thread on a lathe, and the lathe is reversible, then I can ... crank the cross-slide back far enough to be ... any mark on the dial will do. ...
    (rec.crafts.metalworking)
  • Re: Thread cutting on a reversible lathe
    ... If the latter, then you were probably cutting metric threads, and the ... cutting a thread on a lathe, and the lathe is reversible, then I can ... crank the cross-slide back far enough to be ... any mark on the dial will do. ...
    (rec.crafts.metalworking)
  • Re: Tool Box on board .. what goes in the box
    ... because I've found that tools tend to accumulate on boats as the years ... There's a little mark near ... "Why do we need wood lathe tools on a sailboat with no lathe?", ... Lucky for me electronics tools are small and don't weigh much, ...
    (rec.boats.cruising)
  • Re: How to handle stored procedure in VBScript
    ... >> Hi Mark, ... >> I still have troubles to grab that message. ... >> objDBconnection.open sConnection ...
    (microsoft.public.vb.database)