Poorly Fitting Holders Dixon Type QCTP Myford Size

As a favour for a friend I bought him a genuine Dixon QCTP (Myford
Size) as I picked up up some other things for myself. He is now
moaning that his cheap "patern" holders do not fit well. Apparently
the large 45 deg (?) faces are further apart on the genuine tool post.
Has anyone else found this problem? If so has anyone found a source of
patern (read as cheap) holders that fit properly. Any help appreciated
otherwise it seems I have inadvertantly bought myself another QCTP.

Regards

Keith

.

Relevant Pages

  • Re: Purchased the Leblond
    ... of holders, ... When I finally bought my lathe I was tired and fed up with looking. ... Bob AZ ...
    (rec.crafts.metalworking)
  • Re: Are Air-Tight capsules safe???
    ... they are the same holders. ... I've bought from them in the past, a very reliable seller. ... E' mai possibile, oh porco di un cane, che le avventure ...
    (rec.collecting.coins)
  • Re: Carbide Insert lathe tools
    ... i bought a set of the glanze tools and to be honest they are ... holders, but i would recomend making your own holders from a bit of sq ... photo on that page, bottom of the photo,). ...
    (uk.rec.models.engineering)
  • Re: Keeping hydrangea blue
    ... Charlie, gardening in Cornwall.http://www.roselandhouse.co.uk ... Holders of National Plant Collections of Clematis viticella and ... the blue stay blue etc. except for one I bought a few ...
    (uk.rec.gardening)