Re: Eagle No2 Surface Grinder
- From: John Stevenson <john@xxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Thu, 13 Oct 2005 18:16:51 GMT
On 13 Oct 2005 10:39:14 -0700, "Peter Neill"
<panuno95-ukrec@xxxxxxxxxxx> wrote:
>Martin & John, thanks for that info. If I can trouble you both again,
>do you think a a motor of this age would be compatible to run off a
>phase convertor, and if so, could you point me in the direction of a
>reasonably priced item?
>The motor is 1hp with a speed of around 1450rpm. Thats as much as I
>could read off the nameplate without de-mounting it.
>Electrics are a curse with me. I've always considered myself to be
>reasonably mechanically competent, but the moment I'm faced with much
>more than a 3-pin plug I draw a total blank.
>Thanks
>
Peter,
No reason why this shouldn't run off a phase converter.
try these people, no connection but I have had some converters from
them with no problems.
http://www.boost-energy.com/boost/
--
Regards,
John Stevenson
Nottingham, England.
Visit the new Model Engineering adverts page at:-
http://www.homeworkshop.org.uk/
.
- References:
- Eagle No2 Surface Grinder
- From: Peter Neill
- Re: Eagle No2 Surface Grinder
- From: John Stevenson
- Re: Eagle No2 Surface Grinder
- From: Peter Neill
- Eagle No2 Surface Grinder
- Prev by Date: Re: Eagle No2 Surface Grinder
- Next by Date: Re: Eagle No2 Surface Grinder
- Previous by thread: Re: Eagle No2 Surface Grinder
- Next by thread: Re: Eagle No2 Surface Grinder
- Index(es):
Relevant Pages
|
