Re: Wot on earth are an audax?




dkahn400 wrote:
bugbear wrote:

"Fifty millimetres, please," I said, thinking fast.

"We've got one inch or two inch," came the reply.

I knew an engineer, would you believe, who walked into a stationer's
shop and asked if they had a 6" metric rule.

you may laugh but my brother went into a electrician's shop and asked
for a 6' Flourescent tube; they said "sorry, don't sell them any more,
you'll have to have a 1813mm one" (and that is exactly what it said in
the catalogue)

I also own a 6" metric rule (although TBF it's also in inches)

Going back to averages; there is a lower limit of 10kph on BP's but it
can be higher, if I raised mine to 12.5 I could go home (counts on
fingers) minutes earlier, but would lose the charming old couple from
the village who do it every year (being the only ride to start from
there) as they would not get back on time.

.



Relevant Pages

  • Re: Wot on earth are an audax?
    ... bugbear wrote: ... "We've got one inch or two inch," came the reply. ... I knew an engineer, would you believe, who walked into a stationer's ... shop and asked if they had a 6" metric rule. ...
    (uk.rec.cycling)
  • Re: Now this is a power hacksaw
    ... lathe a 18 inch Sidney herringbone gear with a 10 foot bed or maybe ... +E 32 inch shaper at 9500 lbs. ... Also have a Bridgeport J head, ... shop that went under, stops by every once in a while to use the shop ...
    (rec.crafts.metalworking)
  • Re: Now this is a power hacksaw
    ... lathe a 18 inch Sidney herringbone gear with a 10 foot bed or maybe ... +E 32 inch shaper at 9500 lbs. ... Also have a Bridgeport J head, ... shop that went under, stops by every once in a while to use the shop ...
    (rec.crafts.metalworking)
  • Re: Garden Centre Delights
    ... inches long and half an inch wide. ... Thinking of zero volt bus bars in my ... Instead, as the women exit the shop, ...
    (rec.audio.tubes)
  • Re: Shop Heat
    ... and an inch or sor more forward. ... side pieces of the hooks, which would let it come down an inco or so ... just read your post and wondering if your shop is near your house. ... duct with a T and bought heat into my shop. ...
    (rec.woodworking)