Re: suggestions for budget amp?



tony sayer wrote:

Signal<nobody@xxxxxxxxxxx> writes
tony sayer <tony@xxxxxxxxxxxx> wrote:


However, a used 8000A is going to be old now.

And so what do you think is going to have deteriorated?, or they've
bettered since it was designed?.

Electrolytic caps, switches and rotary controls (potentiometers) will all have
some 'wear'.

Graham

.

Relevant Pages

  • Re: Pioneer SX1010 popping noise
    ... cut', 'low cut' & ... '-20 db' switches also the 'tone on/off' switch. ... electrolytic caps, usually 2.2 uf or lower, and 25 volt. ... Remember, it could be DC coming in before the switches, or DC getting ...
    (sci.electronics.repair)
  • Re: Some "grams and speakers" of interest;)
    ... tony sayer wrote: ... Of course if it uses VCAs ... The actual faders survive ok - it's the other pots, eq, aux etc and all ... the routing switches that commonly give problems. ...
    (uk.rec.audio)
  • Re: Firepower question
    ... There are 22uF Electrolytic caps + 100ohm resistors in series that act ... as snubbers across all 6 of the Special solenoid switches on ... Where two switches are wired in parallel as on pinball kickers, ...
    (rec.games.pinball)