Re: Roland RP-11G

Richard Hutchinson wrote:
> Thanks, I was hoping for an XP driver, but I'll setup a PC with 98
> just for the plotter.
>
> I don't suppose you know where to get the cutting blades ?

You could try http://www.luberth.com/help/shop.html

or http://www.signwizard.co.uk/vinyl_cutter_blades.htm

or http://www.beacongraphics.com/knifeblades-roland.html

All 'Roland' blades seem (from the websites) to be the same fitting, since
they don't mention model numbers, only different blades for different
materials.

I don't know if the RP-11G is the same as the current ones though.


.

Relevant Pages

  • Re: Printing on non-standard size paper
    ... Dale wrote: ... all have the same problem tha Project does not see the plotter. ... If a driver update is necessary, ... The problem appears to be limitations in the Page Setup. ...
    (microsoft.public.project)
  • Re: Roland RP-11G
    ... Thanks, I was hoping for an XP driver, but I'll setup a PC with 98 just for ... the plotter. ... Prev by Date: ...
    (uk.comp.peripherals.misc)
  • Re: AoE driver inclusion into standard kernel release
    ... > I would like to discuss getting my AoE protocol driver ... AoE ... > blades, the only device to currently support the AoE protocol. ... > EtherDrive blades, please visit www.coraid.com. ...
    (Linux-Kernel)
  • Re: The BladeCenter Saga -> bge driver not behaving properly...
    ... Our driver does not handle autonegotation for the blades correctly. ... Also, if you haven't used these blades much, the external switch ports ... You might find the kernel config at ...
    (freebsd-current)
  • Re: WWII 30T vs Amana 40T - Blade Test
    ... blade lowered till bottom of sharpened tooth ... setup I rarely need to sand and get a better finish than sanded. ... The blades are still plenty sharp for scrap cutting and I ... it for veneer thin cuts. ...
    (rec.woodworking)