Re: Terminations ... I'm going to connect have duplex LC connectors.... This is typically what I buy for fiber assemblies.... Since the fusion splice machine costs... If they mess up your fiber pull, then you're hosed on that pair. ... (comp.dcom.cabling)
Re: RF antenna cables...revisited ... right die set can build a pretty bomb-proof BNC cable....Crimps done right are superb BUT there are a lot of 'marginal' crimps out ... impossible to pull the cable out of a correctly crimped BNC. ... They were very impressive for the "F" connectors.... (rec.arts.movies.production.sound)
Re: Maximum Current Draw of FPGA ... exposed on the connectors through 390 ohm resistors.... I prefer to connect the positive end of the LED to VCC end pull... (comp.arch.fpga)
Re: Bye bye 49g+! Hello 50g! ... the re-formulation of plastic material?) ...connectors.... I haven't yet had a reason to pull apart a 50, ... (comp.sys.hp48)
Re: Neutrik: the good, bad and ugly ... In my experience the plastic screw-on strain relief at the rear of the connector cracks and breaks fairly easily. ... Yeah, everything breaks eventually, although I've never had a Switchcraft strain relief fail.... The Neutriks I've used have tended to fail within months. ... Now, I just looked on Neutrik's website and they make 9different models of XLR cable connectors, and that's not counting panel mount connectors or distinguishing between male and female. ... (rec.audio.pro)
