Re: Does frequent rebooting harm a computer?



The message <j9t6k1dnc75u6rqc9g0kimv1dcea3hj5da@xxxxxxx>
from kony <spam@xxxxxxxx> contains these words:

> On 04 Oct 2005 21:39:15 GMT, if <if@xxxxxxxxxxxxxxxxx>
> wrote:

> >kony <spam@xxxxxxxx> wrote in
> >news:mq13k19lr37of0022s7oul9bsfsvs7u2fs@xxxxxxx:
> >
> >> There are simple things one can do IF they decide they're
> >> going to leave their monitor fully on, like using a blanked
> >> black screensaver, that quite significantly reduce power
> >> consumption
> >
> >A screen saver makes little difference. According to my Iiyama handbook,
> >power consumption = 110-130W (17" CRT), with a blank screen being the 110W
> >end. Assuming an average of 120W during use, you would only save about 10%
> >with a blank screen saver.

> Then your handbook is either wrong or non-applicable to most
> monitors, or you are simply misinterpreting the handbook
> (most likely). You are randomly assuming blank means the
> low end of the 110W scale, right? If that is actually what
> it says in the handbook then there can be no doubt the
> handbook is just wrong. There is direct correlation to the
> screen output and power consumption, which will be well
> below 50% with a blank screen on any CRT of typical (15" or
> larger) size.

You don't possess a wattmeter, do you?

> >In contrast, putting the monitor into standby
> >reduces power consumption to under 10W, a 90% saving, and suspend mode to
> >6W, a 95% saving. Even so, the handbook recommends turning the monitor off
> >completely at night. I expect most CRT monitors have similar figures.

> Why would you expect it? You have no basis for that.


> >
> >
> >. It must be put in perspective though... Do you
> >> pack additional insulation around your refridgerator to save
> >> $ on it's energy usage?
> >
> >I've made sure I got an energy efficient fridge.

> So in other words, no you didn't. Just as your fridge is
> "energy efficient', so are most (all now?) monitors. You
> are indiscriminately and arbitrarily picking one way to
> suggest power savings but ignoring others. That's fine if
> you choose it, but it is not quite the same thing as an
> ideal about power conservation.


> >
> > Do you always turn off all lights
> >> in your house
> >
> >Yes in rooms not in use, doesn't everyone? Also, compact fluorescents save
> >about 80% of power used by lighting, each £3 CF bulb will save at
> >least £50
> >of electricity during its lifetime, making it an excellent investment.

> Actually it's often more cost effective to use a lower level
> of lighting and NOT turn them off in habitated areas when
> using fluorescents, and to not use compact fluorescents.


> >
> >then turn down the brightness on your TV to
> >> save on it's power?
> >
> >As noted above, screen brightness has little impact on power
> >consumption of
> >a TV or monitor.

> yes you stated it, and you were wrong.


> > It's not the electron beam that consumes most of the
> >power.

> Oh? What would you claim is?

> >TVs use less power than monitors anyhow (my 21" only uses 50W) since
> >power consumption is roughly proportional to signal frequency, and the low
> >resolution and slow refresh rate of a TV compared to a monitor means it
> >only uses a fraction of the power despite the larger screen size.

> Nonsense. A 21" CRT does not use only 50W. LCD, maybe, but
> then we're talking apples and oranges.

> >
> >In the cooler months of the year, do
> >> you recognize that the power used by a computer is heating
> >> the room so there could be a lower HVAC utilization if you
> >> plan for that?
> >
> >Gas is only about 1/4 of the price of electricity though, so electronic
> >equipment isn't the best way of heating your house, and often doesn't
> >deliver the heat when or where it's most needed.

> Actually you're quite wrong, electrical heat from computers
> or lights are almost always delivering the heat exactly
> where it's needed, right where the person is.

--
Regards, John.

To reply directly, please remove "buttplug" .Mail via the
"Reply Direct" button and Spam-bots will be rejected.

.



Relevant Pages

  • Laptop goes on standby, or stops responding after screen saver - but standby is disabled
    ... monitor after 25 mins. ... Password on power-up from standby is enabled. ... I very rarely run off the battery, usually it sits on the AC power all day. ... Several times I've seen it skip the screensaver completely, ...
    (microsoft.public.windowsxp.general)
  • Re: gdm crashes unexpectedly every now and then
    ... wake the monitor from sleep, and usually I am downloading a web page in ... My screensaver is a blank screen. ... It could be related to acpi power management and the xorg server. ...
    (Debian-User)
  • Re: Lets go Dynamic
    ... They inserted a dynamometer setup in the chain - i.e. a measuring device able to generate an absolute measure & record of instantaneous force & speed throughout the stroke. ... With the data from this equipment, they compared input power with the monitor record on the RP, and found this correlated very well throughout the power range. ... They also found that the monitor readings on a C-II machine, which they also fitted with the same dynamometer arrangement, were themselves less accurate. ...
    (rec.sport.rowing)
  • Re: Totaly toasted :(
    ... My old eyes can't zero in on the small fonts on a 36" LCD TV that was my monitor. ... The power supply has a label on it, with a brand name and model number. ... If you don't actually have an IDE connector inside your new computer, ... Ultra ATA 133/100/66/ hard disk drives to the latest Serial ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: NEC AccuSync 120 Schematics/parts? Think my Horizontal output is Failing
    ... Yeah, come to think of it, I've never seen a power device come back from the ... > the fault that you are describing is the high voltage multiplier. ... > believe that on your monitor it is part of the flyback assembly. ... I am really hoping it's not IN the flyback transformer. ...
    (sci.electronics.repair)