Re: FS: Intel 24-port 10/100 hub

Some additional specs:-

Manufacturer's product description
The Intel Express 140T Hub is designed for workgroups of 16 to 46 nodes.
It is rackmountable and available in 16- and 24-port versions.
Express 140T offers flexible 10/100Mbps autosensing - all ports automatically
deliver the highest bandwidth supported by any connected device.

(Please note I do not have the rack mount brackets).

General

Device Type: Hub - stackable

Enclosure Type: Rack-mountable - external

Width: 44.1 cm

Depth: 23.7 cm

Height: 5.5 cm

Weight: 3.9 kg

Enclosure Colour: Grey

Networking

Ports Qty: 24 x Ethernet 10Base-T, Ethernet 100Base-TX

Data Transfer Rate: 100 Mbps

Data Link Protocol: Ethernet, Fast Ethernet

Connectivity Technology: Wired

Switching Protocol: Ethernet

Status Indicators: Port status, link activity, collision status, power,
network utilization

Features: Auto-sensing per device, stackable

Compliant Standards: IEEE 802.3, IEEE 802.3u

Expansion / connectivity

Interfaces:

* 24 x network node - Ethernet 10Base-T/100Base-TX - RJ-45 female - 24
* 1 x network stack device - Ethernet 10Base-T/100Base-TX -
RJ-45 female - 1 power

Power Device: Power supply - internal

Installed Qty: 1 (installed) / 1 (max)

Voltage Required: AC 110/220 V ± 10% ( 50/60 Hz )

Environmental parameters

Min Operating Temperature: -10 °C

Max Operating Temperature: 55 °C

Humidity Range Operating: 5 - 95%

Max Altitude Operating: 3 km
.

Relevant Pages

  • Re: DTMF dead?
    ... connectors, transformers, code size, etc) why ethernet doesn't fit in ... You can still use a PoE controller IC even if you don't have "real" Ethernet ... power provider system. ... The less wires, the thicker each wire. ...
    (sci.electronics.design)
  • Re: How to use Visual Studio 2005 debugger when I boot from Compac
    ... have ethernet connectivity on the device when running from CF (you can ... The image I boot from platfrom builder has the ... "Henrik Viklund" wrote: ...
    (microsoft.public.windowsce.embedded)
  • Re: Installing a network printer in peer-to-peer network
    ... it does have Ethernet built in. ... >> Most printers do not have Ethernet connectivity so whether or not yours ... How you'd assign a network address to the printer would ... >> * PLEASE post all messages and replies in the newsgroups ...
    (microsoft.public.windowsxp.network_web)
  • Re: Debugging (VS2005) an app with threads above default priority
    ... VS2005 only uses CoreConn, so that shouldn't be a problem. ... that's what you're thinking of, was even easier to use over Ethernet only, ... And thanks for the suggestions re ditching ActiveSync - I'll have a look ... connectivity issues with this target board, so I've tended to push the ...
    (microsoft.public.windowsce.app.development)
  • Re: DTMF dead?
    ... connectors, transformers, code size, etc) why ethernet doesn't fit in ... they're really just your standard switching converter ICs with a simple "protocol" thrown on top to let the controller "handshake" with the power provider system. ... is an ethernet connected device acting as a bus master. ... If you have any choice, go with a standard cable, like a four twisted pair ethernet type, and then use PoE for your power, and then two of the pairs for your communications. ...
    (sci.electronics.design)