Tankless Water heaters for heating molds in Injection Molding

Hello,

I am trying to develop a down and dirty, quick and easy way
to make a thermolator for a short run mold.

The requirement calls for a heated front half of mold,
and we only have chilled or tower water available
to plumb the mold. I really don't want to go to the
expense of buying a thermolator for the shop, because
we don't hardly run engineering plastics. Sure, I could buy
a used unit, but this idea is really getting the brain crunching.

Has anyone tried to use one of those hotel-type
under-the-sink mini water heaters to heat the water
going to the molds?

I want to try the concept. From what I have gathered from
the websites, I will have a small amount of water flow, and
I can run the electric unit off of 110V household current. From
a practical standpoint, it sounds as if it may work. But I would
like to get some feedback from the local Injection Molders as
to what their opinions would be.

Many Thanks,

Craig

.

Relevant Pages

  • Re: Disney on a Dime on The Travel Channel
    ... The shower in our master bathroom got to be so bad that we could clean the mold out with bleach and within an hour, ... The reason was the shower pan liner had failed, allowing water into the walls and framing. ... The tile was put on plain sheetrock and the vinyl liner had been cut and installed wrong so it didn't hold water. ...
    (rec.arts.disney.parks)
  • Re: 2000 Chrysler Voyager-Interior Smell
    ... core is in. ... leave condensate water in the evap core and the water takes a long, ... Once you have a nice crop of mold in there, ... There are a few companies that make a foam that you drill a hole in the evap ...
    (rec.autos.makers.chrysler)
  • Re: How to rid homes of the mold from Katrinas flooding?
    ... because of the contents of the water i'd remove all ... It could also be airborne spores ... Mold spores are everywhere, they are dormant without moisture, it could ... Certified mold remediation and water damage restoration specialist/ ...
    (rec.martial-arts)
  • Re: How to rid homes of the mold from Katrinas flooding?
    ... > wetness and beyond as water will wick up and insulation. ... It could also be airborne spores ... > Mold spores are everywhere, they are dormant without moisture, it could ... Certified mold remediation and water damage restoration specialist/ ...
    (rec.martial-arts)
  • Re: 2000 Chrysler Voyager-Interior Smell
    ... core is in. ... leave condensate water in the evap core and the water takes a long, ... Once you have a nice crop of mold in there, ... There are a few companies that make a foam that you drill a hole in the evap ...
    (rec.autos.makers.chrysler)