Re: Question: Steam Flow Restriction
Folks:
Regarding the following statement:
"...My second guess was that it is harder to push a liquid
than it is to push a gas through a small tube. So, if the condensation
tube is actually condensing, that may be causing this."
I apologize -- I was dazed and confused when I wrote this, and I wish
to strike it from the record. The fact is, once again, that when I
*add* the condensation coil, the vent time *decreases*.
Any thoughts?
-Mike
.
Relevant Pages
- Re: Question: Steam Flow Restriction
... the 1/4" tube then the choke point might ... >a condensation coil, I observe vent times of 27 sec. to 72 sec. ...
(sci.mech.fluids) - Re: Epson cx6600 problem and needs service ??
... we just push some combination button, ... able to reset my unit using the utility thanks to some anonymous help. ... Above this hatch is what I THINK is the waste ink tube but I suspect it runs for quite a ways along the base before it terminates in the absorbant padding. ... My theory at the moment is that it's going to require a pedestal of sorts to lift the printer up, a cutting or gentle extraction of the tube and then redirection into a container underneath the printer.. ...
(comp.periphs.printers) - Re: Scopes dripping wet
... Condensation occurs when a cold surface is exposed to a warm/humid ... the dewshield/lens assembly screws onto the tube. ... Rubber band it with a couple rubber bands. ... You'll notice condensation all over any remaining exposed tube, ...
(sci.astro.amateur) - Re: "This Old House" tip. ???
... The guy I bought my house from didn't seem to know ... Does anyone pull the tube back? ... I've never seen anyone push it. ...
(alt.home.repair) - Re: Changing forks on a MTB
... I performed this task on an alloy steering tube so if your new tube is ... When you take it out, push it down the tube, not UP ... I think there might be some sort of a "starfangled nut pusher tool" ... Which forks are you going to put on? ...
(uk.rec.cycling) |
|
