Re: Ixys RF Power MOSFET IXZ210N50L & IXZ2210N50L - experience?

Dear Grant,

Have you made some test with the IXZ2210N50L yet?
I´ve received 2 pieces of this Mosfet these days from my local provider.
I am developing a new device to 88-108MHz to Sinteck and I am facing too
many dificulties to stablish a configuration to this RF transistor.
I´ve placed a 9:1 RF transformer to the input section and the transistor
responds very well, but the output drawing is a little complicated to
develop, have you any information about it?
If you can, report me your experience, we can develop it together...

Regards

Luciano - Sinteck


.

Relevant Pages

  • Re: Motorcycle flasher problem.
    ... to turn on the mosfet - you want 4 or more volts there. ... I'd suspect a bad PNP transistor (or wrong transistor or connected ... A good mosfet has almost no gate current - the gate is an insulator - ...
    (sci.electronics.basics)
  • Re: High brightness white LEDs damaged by custom switcher
    ... voltage on the 1 ohm sense resistor reached Vbe, and turn off the MOSFET. ... Maybe an SCR would be better, requiring a complete power down to reset. ... efficiency and battery life are ... I think the additional transistor or SCR will work. ...
    (sci.electronics.design)
  • transistor array ICs (was, analog multiplier help)
    ... >> My impression is that the virtues of dual gate MOSFET mixers have ... >> compensated Gilbert cell multiplier will do much better than a MOSFET ... >> The numbers for the MOSFET would have come from "Transistor Circuits ... As the years went by, GE, RCA and Intersil became owned by Harris, ...
    (sci.electronics.design)
  • Re: Student Question on using a PID as a Dimmer to Control a Light Bulb!!! This is a fun one!!!!!!
    ... field-effect transistor, a common type of transistor in which charge ... Is the MOSFET like a PWM, ... Consider what happens when a switch reduces a constant-resistance load* to quarter power. ... The effective resistance of the control transistor is set equal to that of the load, so that half the voltage appears across each. ...
    (sci.engr.control)
  • Re: Constant Current Source Design
    ... Exchange the PNP transistor with a P-channel MOSFET with low Vgs threshold ... transistor with an N-channel MOSFET and recalculate for your needs. ... >>circuits can be used for building a constant current source. ...
    (sci.electronics.design)
Quantcast