Re: SAD lights again


"jimmyzingo" <jimmyzingo@xxxxxxxxxx> wrote in message
news:VgtAf.10853$ZA2.8537@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> After taking all of your fine ideas from the last go round I have decided
> that I'm not really Sad in the morning--just cold. Now I need a WARM light
> preferably with bright noonday sunshine. Don't suggest outside. Seriously,
> I'm looking for a lamp whose heat will shrink the inside of my nose as if
> I'm at the beach without dangerous UV issues.To further challenge you said
> lamp must either fit my 24" florescent strip or my 175 watt mercury vapor
> mogul socket. Of course an incandescent lamp is OK too.Anybody today wake
> up to warm temps. and beautiful sunshine? Please nominate/rate your city
> as suitable/not for my future retirement destination.Be sure to include a
> sunny/overcast day ratio.


Many of us provided lots of information to your previous request. It's time
to go see a specialist, and have him/her determine why you have trouble
waking up in the morning. Maybe it's none of the things you are guessing it
is. Maybe you have sleep apnea, and are not sleeping at night. Maybe you are
not going to bed early enough. Maybe you are drinking a gallon of Jolt cola
before going to bed? The typical way of handling things that are medically
related is to have the issue diagnosed by a licensed practitioner. If you
are having the issues that you are guessing you have, and they are a medical
condition, they will prescribe the apparatus that you need to resolve the
issue.

As far as the limitations that you've placed on the lighting apparatus.... A
175 watt mogul Mercury Vapor socket takes just that, assuming you have the
correct ballast wired to the socket. Same with the 24 inch fluorescent
strip.


.

Relevant Pages

  • WTB: 120V lightbulb flasher
    ... These are the flashers that go in the socket of a lamp before the bulb ... I'm guessing they're no longer being made. ...
    (rec.games.pinball)
  • Re: Gottlieb System 80 - Lamp fluttering and dead
    ... this lamp. ... rule out a crummy socket. ... Once on the driver board, ... Minutes later, I was fooling with it, fiddling with the "hot" tab ...
    (rec.games.pinball)
  • TECH: Gottlieb System 80 - Lamp fluttering and dead
    ... My Gottlieb Spider-Man's L40 lamp had been really ... switched the socket with one of these nicer, ... Minutes later, I was fooling with it, fiddling with the "hot" tab ... Remove the lamp from the L40 socket. ...
    (rec.games.pinball)
  • Re: Bally Vector GI lighting too bright to look at
    ... measure hot to common at the socket, you don't measure AC to ground. ... through a board and right out to bulbs. ... TP4 on the rectifier board with respect to ground (braided wire inside ... Both lamp drivers are for the Controlled Lamps, ...
    (rec.games.pinball)
  • Failure of 3057 automotive tail lamp
    ... and noticed that the bulb didn't have any black or silver spots on it. ... On this particular lamp, there is a plastic piece on the base that the ... lead wires from the filaments are laid on top of. ... the socket contact these wires when the lamp is installed. ...
    (sci.engr.lighting)