Re: Was given a new 90 AMP BUZZ BOX, what electrodes should I use ?


"N9WOS" <Don't@xxxxxx> wrote in message
news:qRMBl.14995$8_3.4546@xxxxxxxxxxxxxxxxxxxxxxx
'Creep-resistant' is an unfamiliar term for me, please define or explain.
As I mentioned, I have no knowledge or experience of or with rods
designated as 7013. Do they have a specialized use that I am unaware of?
Is their usage industry specific or a regional thing?

If you look at a firebox of an old wood stove with the sides and top
drooping or bloated from long exposure to high temperatures, then you will
have a working definition of high temp creep.,

Creep resistance is the resistance to plastic deformation under long
exposure to high, or elevated temperatures. Like used in boilers, and
such.

One of the big problems is hydrogen embitterment damaging the plastic
properties of the weld joint. You will have some plastic flow and
deformation of the weld joint, no mater what type of rod you use. That is
a result of the cyclic heating and cooling that normally comes along with
high temp applications. All you are trying to do is limit the plastic flow
to a reasonable level to obtain a useful life out of the product. But if
you have some parts of the weld that have become brittle because of
hydrogen entrapment, then that part will crack from the cyclic heating and
cooling (because the brittleness of the metal can't tolerate the cycling
deformation) long before the rest of the joint reaches it's end of life
condition.

I have found the answer.

Some spec sheets have 7013, 8013 and 9013specified as low hydrogen. But in
the same PDF state that drying isn't required. That is counter intuitive.
But I have been forgetting that they are CrMo steel. Or basically hydrogen
resistant steel. Same as the base metal they are designed for.

http://www.alruqee.net/ind_mkt/RIM-CD&WEB/welding_consumable-files/bohler/174en00.pdf

Since they are rutile instead of basic, which mean that the coating isn't
hygroscopic. That means that it doesn't have an inherent problem with the
coating water logging. And the fact is that what ever hydrogen is present,
isn't going to cause the metal any problem, because the metal is naturally
resistant.

So it naturally produces low hydrogen welds, and doesn't need drying unless
it is subjected to extremely wet conditions before use.

Drying won't cause them any problem, but it isn't needed.

That is as long as it is used on the base metal that it was designed for.
That being CrMo steel.


.

Relevant Pages

  • Re: Was given a new 90 AMP BUZZ BOX, what electrodes should I use ?
    ... will have a working definition of high temp creep., ... Creep resistance is the resistance to plastic deformation under long ... deformation of the weld joint, no mater what type of rod you use. ... But I have been forgetting that they are CrMo steel. ...
    (sci.engr.joining.welding)
  • Re: Was given a new 90 AMP BUZZ BOX, what electrodes should I use ?
    ... I have no knowledge or experience of or with rods ... Creep resistance is the resistance to plastic deformation under long ... deformation of the weld joint, no mater what type of rod you use. ... All you are trying to do is limit the plastic flow to a ...
    (sci.engr.joining.welding)
  • Re: converting 110 v glue gun to 12 volt?
    ... Probably just a dumb question..but..if the 110 v unit has a coil of resistance heating wire..and the aforementioned 12 v unit has a coil of resistance wire...can I calculate how much of the 110 v wire I would need to ... thanks sorry for the dumb questions...but you guys know this stuff..I don't. ... temp and high temp. ...
    (sci.electronics.repair)