Re: SIP Migmate spares (UK)

Martin Whybrow wrote:
I'm using a SIP Migmate Pro 170DP Turbo for welding aluminium. I have the
proper Teflon liner in the (Euro) torch but I am getting faltering wire
feeding and occasional poor contact in the tip; looking at the wire, it's
got an embossed pattern on it from the feed roll which has a knurled groove
in the 0.8mm position (using 0.8mm wire). I would like to replace the feed
roll with a proper 'U' groove roll but the manual's spare parts list is a
joke (it simply shows a diagram with the larger items inside the welder) and
has no part numbers; anyone know if a proper parts list exists for the
Migmate, where I could buy a spare feed roll or if it's possible to fit
parts from another make (seeing as these are made in Italy in a factory that
makes at least 2 other brands of MIG)?
TIA, Martin.


SIP are utterly bloody useless - I have been waiting 6 weeks for spare tips for my Plasma cutter - so long, I have decided to turn some of my own up.

Can't you get someone to turn you a suitable roller ?

Steve
.

Relevant Pages

  • SIP Migmate spares (UK)
    ... I'm using a SIP Migmate Pro 170DP Turbo for welding aluminium. ... proper Teflon liner in the torch but I am getting faltering wire ... feeding and occasional poor contact in the tip; looking at the wire, ... where I could buy a spare feed roll or if it's possible to fit ...
    (sci.engr.joining.welding)
  • Re: Red, Green, Black, and White Wires
    ... So, black-black, white-white, bare copper to bare copper. ... And, of course, splices using proper size solderless connectors ("Wire ... Nuts") or other acceptable means, ...
    (sci.electronics.repair)
  • Re: Recommend transistors for PA at UHF?
    ... heatsink, wire up a couple of voltages, feed them with the proper ...
    (rec.radio.amateur.homebrew)
  • Re: Blowing light bulbs
    ... > it would be a lot less expensive to just install a proper lighting system. ... Standard recessed light fixtures and the bulbs that they're designed ... > a wire running along the beams. ...
    (alt.home.repair)
  • Re: Help with MIG spares, German speaker required!
    ... The biggest problem was the wire sticking ... identified as the problem careful working avoided it. ... the wire showed it was embossed from the knurls in the feed roll (the 0.8mm ...
    (uk.rec.models.engineering)
Loading