Re: question about banding


"Han" <nobody@xxxxxxxxxx> wrote in message
news:Xns9EC06C1C79052ikkezelf@xxxxxxxxxxxxxxxxxx
I'm getting ready for this entertainment center I've been planning. 3/4"
maple veneer plywood that I bought 1/4" thinck banding for. I was
planning
to set this onto an existing sideboard, at least for starters. So I'd
thoguht of having a bottom for this with 4 uprights resting on this. Wide
middle for the TV with sliding doors to hide it that slide left and right
in front of bookcase-like sets of shelves that are each about half the
width of the middle.

Questions: On that bottom, do I attach the outside uprights by butting or
dadoing them onto the bottom (with Dominos as strengthening)? Then how do
I put banding on the narrow outside edges of the bottom?

--
Best regards
Han
email address is invalid

I could give all kinds of answers but I am having a hard time picturing.
Got a sketch of the proposed area in question?

O M G !!! You have a Domino?


.