Re: 92" BandSaw Blade

Woodcraft can get you a new blade thru PS Wood, they can order any size
bandsaw blade you might need, besides a very good blade, the price is not
bad.\\

Ken
"Searcher7" <Searcher7@xxxxxxxxxxxxx> wrote in message
news:ed7111c5-69b2-4cc7-81d8-6f34f1661357@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I took the old rusted bandsaw blade out of my 14" bandsaw, cut it, and
measured it at 91-7/8", so I assume that 92" is what I should be
looking for.

In an internet search I can esily find 91-1/2" and 92-1/2" blades, but
not much in the way of 92".

Can I get recommendations on a good place to find a 92" blade mostly
for use in hardwoods and premium plywoods?

Thanks a lot.

Darren Harris
Staten Island, New York.


.

Relevant Pages

  • Re: Best price for needles/blades
    ... As the price of blades here would make you wince, can I just pass on my experience with non-Olfa blades: trying to spend less on blades, I bought 'others'. ... However, then I bought a small bulk box of Olfa at a show, with a few pounds off. ... I hadn't really noticed the change going from an old good blade to a not so good blade; but WOW I certainly noticed going from a bad blade to an Olfa blade - through the fabric like butter, hardly any pressure, no nicks on the edge and they each lasted ... ... "Jennifer in Ottawa" Thats a good price for Schmetz needles and it equals the bulk price ...
    (rec.crafts.textiles.quilting)
  • Re: Does RISC still offer a significant numbercrunching advantage?
    ... Keep in mind that system has $4k tied up in video cards, something the IBM blade above doesn't even have one of. ... I'm not sure how much memory the blade comes with for that price, ... If you want a fair comparison, ask what a blade with similar performance but chips from Intel or AMD would cost. ...
    (comp.arch)
  • Re: Fast cheap SPARC hardware.
    ... I have a Blade 2000, ... on eBay at a price they might actually get for it, rather than what they might hope to get. ... But are there SPARC options I'm overlooking? ... But I know the single threaded performance of a T1000 is going to be worst than the Blade 2000 and in any case, a mate gave me another Netra T1. ...
    (comp.unix.solaris)
  • Re: Bandsaw brands
    ... 1" blade price before tax 1095 NZ$ ... Trupro WBS-20L ... grand on a 16 inch bandsaw, even if it's made in Italy. ...
    (rec.woodworking)
  • Fast cheap SPARC hardware.
    ... Are there any options for fast single threaded SPARC hardware at a cheap price used? ... I have a Blade 2000, ... But are there SPARC options I'm overlooking? ... The 2.52-GHz Sun M3000 Casper mentioned would be nice, but that's not cheap. ...
    (comp.unix.solaris)