Re: Advice Please: Bandsaw & Drill Press Project machines

On Jun 14, 4:10 pm, Nova <nova...@xxxxxxxxxxx> wrote:
Searcher7 wrote:
There is no manufacturer' s website, and no reference to parts for
this Drill Press on eBay.

And the reason for taking it apart is because of the rust. I have no
idea if corrosion has spread to the internal parts of the motor.

And a "simular" motor means finding another 3/4 hp motor, single phase
motor for the bandsaw.

Darren Harris
Staten Island, New York.

See:

http://www.grizzlytools.com/products/Motor-3-4-HP-Single-Phase-3450-R...

Here is a quote I got from someone else: "That drill press sold for
around $80 new in the early 1980's
without an electric motor."
.

Relevant Pages

  • Re: Big hole, little press
    ... What is the nameplate RPM for that motor vs ... it catches at the end of a hole, ... drill press will have sufficient torque -- with the above-mentioned ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... that had upper..lower and middle hardware/couplings and it was smaller ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted ... flexible drive shaft with appropriate couplings from the motor ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... Replace the existing handle with a nut and drive the nut with a ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted ... flexible drive shaft with appropriate couplings from the motor ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted either on ... flexible drive shaft with appropriate couplings from the motor shaft to ... mounted up on the head. ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted either on ... flexible drive shaft with appropriate couplings from the motor shaft to ... mounted up on the head. ...
    (rec.crafts.metalworking)