Re: Advice Please: Bandsaw & Drill Press Project machines

Searcher7 wrote:

.... snip

I'm getting ready to clean them up, but I'd appreciate any
recommendations on where I can get parts.

I assume that I'll have to take the Drill Press' motor apart

The Drill Press has a single phase 3/4" horse power motor that I'll
have to take apart, but I'd like to find a simular motor for the
bandsaw.

Going by the pics, can anyone tell me if there are any specific parts
I should be scouting for?

....snip

Do the motors run? If so, I wouldn't take them apart. Looking at the
pieces, it looks like your biggest problem is rust that is going to need to
be cleaned up.


--
If you're going to be dumb, you better be tough
.

Relevant Pages

  • Re: Big hole, little press
    ... What is the nameplate RPM for that motor vs ... it catches at the end of a hole, ... drill press will have sufficient torque -- with the above-mentioned ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... that had upper..lower and middle hardware/couplings and it was smaller ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted ... flexible drive shaft with appropriate couplings from the motor ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... Replace the existing handle with a nut and drive the nut with a ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted ... flexible drive shaft with appropriate couplings from the motor ...
    (rec.crafts.metalworking)
  • Re: Motorized rack and pinion on Drill Press
    ... motorize the the rack and pinion crack on a drill press. ... My idea would be to use a DC geared reversible motor mounted either on ... flexible drive shaft with appropriate couplings from the motor shaft to ... mounted up on the head. ...
    (rec.crafts.metalworking)
  • Know your local Junkie.
    ... takes a pipe wrench to turn the motor. ... Found, mounted, now what about the pulley? ... Neighbor interested in drill press, I've already got seven, one of which I ...
    (rec.crafts.metalworking)