bench dog router table & router choice

I have a Bench Dog Protop Contractor 40-001 and am undecided which is
wisest choice for its router. It would seem that a plunge router is a
waste as is a variable speed.

My first thought would be to install the PC 690 with a separate variable
speed router control mounted on the box exterior.

Any thoughts on a router without overkill?
.

Relevant Pages

  • Re: Big plunge router usage
    ... All tool manufacturers offer a 3+HP plunge router in their lineup (some ... fixed base router does the job well... ... of 1/2 HP and really has nothing to do with teh weight of the machine, ...
    (rec.woodworking)
  • Re: Routers- plunge vs other kind
    ... safer getting started with a plunge router - position router, start, lower ... A plunge router has a much taller profile than a fixed base, ... Also I see some router kits contain both base types but cost alot more- is ...
    (rec.woodworking)
  • Re: Tool Advice for Beginner
    ... tried to cut through the particle board with a very inexpensive jigsaw ... To lower the lip I think I need to use a router. ... to high quality tools of a jigsaw or plunge router, ...
    (rec.woodworking)
  • Re: Router For Router table
    ... plunge router, but that may be ok for a table unit. ... I've always used a plunge router in a table because of its ease of adjustment. ... I "fixed" this by driving them back into correct position, then drilling holes through the housing and into the bushings and installing short roll pins to keep them in place. ...
    (rec.woodworking)
  • Re: Big plunge router usage
    ... All tool manufacturers offer a 3+HP plunge router in their lineup (some ... The fixed base provided two large ... must be over 10 plunge router monsters available but only 2 fixed base. ...
    (rec.woodworking)