Re: Drawers
On Wed, 30 Jan 2008 17:51:51 -0800, Trent <trentlREMOVE@xxxxxxx>
wrote:
Installing some drawer slides on an old kitchen cabinets but when I
install the drawers left corner sticks out further than the right when
closed. I am sure the cabinets are to blame, for I know my drawers are
square. I thought I read a post on how to correct this with shims in
an earlier post but cannot find it. Anybody have any ideas?
Check to be sure the front of the slides are lined up in the front of
the cabinet. If they are flush make sure they are both flush or at
least both the same. If that's not the problem, and the front left
side of your drawer hanging out, you will need to move the back of the
drawer guides in the opposite direction (to the right). Depending on
how they are attached, you may be able to put something behind one
guide but the other side might be a little more tricky.
Mike O.
.
Relevant Pages
- Re: googling for N.O. rape victims
... > drawer fronts are all being replaced, and the drop-in stove was ripped ... I'll frame out the space for the new drawers and cupboards ... > want for solid slab so I'm going to do a stone tile countertop. ... now we are sanding the cabinets and painting them. ...
(alt.true-crime) - Re: Another Question About Shop Storage
... I dislike stuff on shelves, ... I'm slowly adding doors to my open cabinets for the same reason. ... lots of big drawers and some small ones. ... reach on the pegboard for things, and I can put more in drawers than on ...
(rec.crafts.woodturning) - Re: OTP, question about kitchen cabinets
... I broke my ceramic cooktop within a month of moving in. ... and pressure release latches (might not go there, because the doors would ... My 2 cents--if you do get new cabinets put on handles you can get your ... drawers that somehow self-close are also nice. ...
(alt.support.arthritis) - Re: First Visit
... compartment, where the shore power cable is and there is no socket to ... Without putting them in the part of the cabinets not open to the ... drawers are just stacked, and then screwed to the side with a ... If you took pictures of him, ...
(rec.outdoors.rv-travel) - Re: Coin envelopes for SMT part, where?
... But then they take up more space and I can't get them into parts drawers. ... in stock, so I can just grab anything from stock. ... Occasionally they show up at a yard sale and the envelopes would fit into those. ... Maybe even into some 3-1/2" disk cabinets. ...
(sci.electronics.design) |
|
