Re: Rules on pre-drilling sizes for screws

Let's go to the source:

http://www.wlfuller.com/html/what_size___.html

PS: One of the older and largest producers of drill bits.




Thomas G. Marshall wrote:

I'm never quite sure what the best practices are for pre-drilling holes for screws.

What I have been doing is holding the drill bit in front of the screw at eye level and trying to sight it to see if I can still see the shaft of the screw behind it. If I can just /barely/ see it, then I know that the screw's shaft will be a smidgeon larger than the hole it's teething into, and that's what I'm aiming for usually.

Note, I'm not talking about the case where I need a hole large enough in a board for the threads to spin freely to pull the board down to something underneath. I'm talking about the underneath business, but perhaps there are rules for the board here too.

Fundamentals:

1. Does pre-drilling generally create a stronger hold, because presumably there is less wood pushed to the side of the screw? Or does the stress of the wood split to the side add to the hold against the threads?

2. Should a pre-bore be large enough to only grab the threads? Or is this only necessary for the harder of the hard woods?

Thanks!


.

Relevant Pages

  • HF pipe threader any good ... NO !
    ... I got the mill drill, crap, its just a drill press, the idiot's ... Drywall screw driver is good, ... dowel pins to quick find 3 sided plug gages! ... BTW welding is religion and weld sales people are preachers ...
    (rec.crafts.metalworking)
  • Re: Ultra thin screwdriver
    ... go back to the original screw if you need to.) ... There's just a scale. ... It's a cheap drill press. ... of steel plate crimped onto a length of threaded rod. ...
    (rec.crafts.metalworking)
  • Re: footstrap screws
    ... This is not a 1/4-20 bolt, or even a #6-32 screw thread! ... The minor dia. ... drill something this small with a tiny .125-.187" drill. ... and once it work hardens, ...
    (rec.windsurfing)
  • Re: Rules on pre-drilling sizes for screws
    ... What I have been doing is holding the drill bit in front of the screw at eye ... screw's shaft will be a smidgeon larger than the hole it's teething into, ... I'm talking about the underneath business, ... the wood split to the side add to the hold against the threads? ...
    (rec.woodworking)
  • Re: Kerry Stairs TOTAN Protector - Where Does It Go?
    ... Mark the holes with a pencil. ... > around with the drill bits, get a nail set and a hammer. ... Now go ahead and start your wood screw. ...
    (rec.games.pinball)