Re: Square fence on Delta Mortiser
On Mar 30, 3:09 pm, "sce" <spen...@xxxxxxxxxxxxxxx> wrote:
Hi,
I just received a Delta 14-651 Hollow Chisle Mortiser and when setting
it up found that the fence is not square with the base (tilts back
about 1/8"). The Instruction Manual does not cover this adjustment.
Does anyone have a suggestion on how to square the fence?
Thanks,
Spencer
Maybe attach a fence to the fence, and shim it? Tom
.
Relevant Pages
- Re: Ques regarding the Chopper by NWSL
... "top" of the base, near the fence. ... extruded box section that mounts the sandpaper wasn't very "true" (square). ... > countersunk holes on the bottom for the handle screws. ...
(rec.models.scale) - Re: How can I make this cut repeatably on my table saw
... Place the square on the table so the ... I plan to make the 4 sides of the trivet out of cherry with a roundover ... that the flat side of the board is up against the fence, ... having the cut round overs being slightly different width which will not ...
(rec.woodworking) - Re: How can I make this cut repeatably on my table saw
... Place the square on the table so the ... I plan to make the 4 sides of the trivet out of cherry with a roundover ... that the flat side of the board is up against the fence, ... having the cut round overs being slightly different width which will not ...
(rec.woodworking) - Re: Squaring bed posts
... If you happen to have two convex sides start jointing in the middle of the side rather than from the end. ... After the first face is jointed full length then use it against the fence with the same technique over the length. ... Also I checked the jointer before use to be sure the fence is square to the table and the tables are planar. ...
(rec.woodworking) - Square fence on Delta Mortiser
... I just received a Delta 14-651 Hollow Chisle Mortiser and when setting ... it up found that the fence is not square with the base (tilts back ... Does anyone have a suggestion on how to square the fence? ...
(rec.woodworking) |
|
