Re: How do I rout a panel out of a frame?

How about just trying to veneer over the ugly ply.
Toller wrote:
I have a cabinet with a plywood panel door. The plywood didn't look too
good when I finished it, and a year later it looks even worse. I have to
fix it.

I would just as soon not replace the frame it is in. My plan was to rout
the back off, remove the bad panel and put a better one in. I am not quite
sure how I was going to retain the new panel, but it can't be that hard.

But now I realize that to do this on a router table, I will have the work
between the bit and the fence. Last time I tried that I got a rather nasty
kick back; but I don't really see any other options.

I am tempted to forget it and take vinigar and water to the glue. Has
anyone ever succeeded at that?

.

Quantcast