Re: router cutting ovals
- From: technical123@xxxxxxxxxxx
- Date: 29 Jul 2006 22:51:02 -0700
Thanks for the links
Will look into them
CW wrote:
Just ran across this one. Should do what you want.
http://www.highlandwoodworking.com/library/infiniteovaljig.pdf
<technical123@xxxxxxxxxxx> wrote in message
news:1154197741.902651.245360@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I have been searching for a router attachment to cut ovals. Have looked
at a few co's attachments and a couple of plans on the web.
My problem however is that the ovals I need do not have a big enough
difference between the length and width.
I am looking at making oval wood frames, various sizes but for example
- 42"long by 38" wide or 48" long by 44" wide.
The prof attachments all seem to have differences like 14" rather than
4".
Any ideas please.
Thanks very much
.
- References:
- router cutting ovals
- From: technical123
- Re: router cutting ovals
- From: CW
- router cutting ovals
- Prev by Date: Re: Hollowing out telegraph poles
- Next by Date: Foredom handpiece mystery
- Previous by thread: Re: router cutting ovals
- Next by thread: Re: router cutting ovals
- Index(es):
Relevant Pages
|