Re: table saw fence

Buy a solid knob, then drill and tap as req'd.


If the threading on the knob (either bolt or nut) is a common size
(i.e. 1/4-20 or 5/16-18) you could probably find a replacement in the
"jig hardware" sections of Lee Valley, Rockler, etc.
http://www.leevalley.com/wood/page.aspx?c=2&cat=1,43455&p=52800
Good luck,
Andy

.

Relevant Pages

  • Re: table saw fence
    ... "jig hardware" sections of Lee Valley, Rockler, etc. ... Good luck, ...
    (rec.woodworking)
  • Re: McFeelys
    ... 'Lee Valley' with no problem. ... Hope you can get this sorted as I would like to get some goods from ... most part, nothing Woodcraft, Rockler or Lee Valley sells comes close ...
    (rec.woodworking)
  • Re: metal screw inset
    ... Lee Valley or Rockler ... Also see McMaster Carr: ... About the time I had mastered getting the toothpaste back in the tube, ...
    (rec.woodworking)
  • Re: Any ideas for installing a router into a mobile workbench?
    ... Check with the likes of Rockler, WoodCraft and Lee Valley also. ... Thanks for the website. ...
    (rec.woodworking)
  • Re: Jet mini opinions: VS or not?
    ... Klingspor had been the only place I'd tried with no ... luck. ... Lee Valley is not only a good place to shop and has excellent customer ... I ordered an additional post to fit the mini so the get a little more ...
    (rec.crafts.woodturning)