Fitting Ryobi laser circular saw into case?

I have what has to be the ultimate boneheaded question.

I purchased a Ryobi circular saw, the 7 1/4" laser version. I took it
out of its case, installed the blade, made my cuts - and now, for the
life of me, I can't figure out how to fit it back in its case! I've
turned it this way and that, have found some orientations that almost
work but would require twisting the cord at an odd angle.

This isn't the worst problem in the world, but it is annoying. Does
someone else on this group have one of these saws, and know how to fit
it back into its case?

Thanks -

.

Relevant Pages

  • A Few Specs on the Varo Er:Cr:Glass laser
    ... Cr:Er:Glass eyesafe laser range-finder that I used to assemble for IMO ... Estimated cost of the rod was $700. ... The tabs that fit into the end piece slots had to be under ... O-rings: There were two sets of o-rings. ...
    (sci.optics)
  • Re: Coreing systems
    ... At least the cutters should fit into the rig but would the rig permit an angle for hollowing. ... I have the kelton laser rig and love it but I don't think it will attach to the center savers. ... My application requires that you modify the attachment to make it fit the hollowing tool handle. ...
    (rec.crafts.woodturning)
  • Re: laser projector for disco hall,outdoor ad.and other special events
    ... powersand colors to fit any budget or venue. ... Big power laser projector: Model: DW-303 ... Single color Laser Projector: ...
    (sci.electronics.misc)
  • Re: Strange !!! Playstation 2
    ... You want to return it to the repair outfit and get him to fit a proper laser ... unit and not one of the cheapo ones you can get for $10. ...
    (sci.electronics.repair)
Loading