Re: Revised Router Question
- From: "Mike Marlow" <mmarlowREMOVE@xxxxxxxxxx>
- Date: Fri, 17 Mar 2006 16:02:10 -0500
<petegladstein@xxxxxxxxx> wrote in message
news:1142603102.406650.96950@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I need to dado a 3/4" width and 3/8" depth in oak plywood. I will be
using a 3/4" carbide tip straight bit with a 1/2" shank. Can I do this
in one pass? What speed should I set my router?
I've routed 3/4 X 3/8 deep in one pass many times. My router is a DeWalt
618. I've left mine on the highest speed and plowed through as the router
would take it. I've also done it in two passes. I guess it depended on how
much of a hurry I thought I was in or if I was feeling gutsy or something.
Try a scrap. If it does not route through well then reduce the depth of cut
and do it in two passes. If you're really concerned about router speed -
read your manual. What does it suggest? What does it suggest for depth of
cut?
Both of these questions can well be answered by the information found in
most router manuals. It does pay to read the manual.
--
-Mike-
mmarlowREMOVE@xxxxxxxxxx
.
- References:
- Revised Router Question
- From: petegladstein
- Revised Router Question
- Prev by Date: Re: Table saw jig
- Next by Date: Re: The Sin of coloring cherry
- Previous by thread: Re: Revised Router Question
- Next by thread: Re: Revised Router Question
- Index(es):
Relevant Pages
|
Loading
