Re: How would you make this pull?

Draw out the profile as if it's sitting on a table top and you're
looking at it from the side. Based on Rockler's dimensions, it would
be mushroom shape 1" wide and 3/4" tall. Duplicate the pattern
numerous times (I'd just draw it out on my computer and print it).

Then, take a 1.5" x 1.5" square of maple 1" thick (to go with your
son's dresser, right?), and tape your pattern on two adjacent sides,
lining them up in the Z direction. Cut out the profile using a scroll
saw like it was a big thick jigsaw puzzle. After you do it in the X
direction, tape the two pieces back together, and then do the cut along
Y.

When you're done, just soften it up with some sandpaper or a file.

Josh

.

Relevant Pages

  • Re: tent dress altering questions (bust)
    ... My plan was to take the pattern and draw an angled line down from the sleeve hole to make it more billowy but how do I accommodate her bosom without making the upper body section to large? ... the point of the dart. ... quadrant of the pattern with the center front on the center front line ...
    (alt.sewing)
  • Re: tent dress altering questions (bust)
    ... I'd copy the pattern, since enlarging a bust whacks the pattern up ... the point of the dart. ... Draw vertical and horizontal lines through the ... quadrant of the pattern with the center front on the center front line ...
    (alt.sewing)
  • Re: API Drawing, hatch, can I orient the hatch?
    ... Bitmap so you could just draw your rotated hatch ... > pattern into a Bitmap, create a pattern brush from it, select it into the DC ... and use the PolygonAPI call to draw your shape. ...
    (microsoft.public.vb.general.discussion)
  • Re: API Drawing, hatch, can I orient the hatch?
    ... Bitmap so you could just draw your rotated hatch ... > pattern into a Bitmap, create a pattern brush from it, select it into the DC ... and use the PolygonAPI call to draw your shape. ...
    (microsoft.public.vb.winapi.graphics)
  • Re: Advice on rustication
    ... I just want it to enhance my staff carving a bit. ... You asked for advice, here is advice worth every penny it cost. ... Do not draw or make a pattern and then follow it. ...
    (alt.smokers.pipes)