Re-DeWalt 733 planer blade change

Thanks for the reply`s for changing the blades on my DeWalt 733. The jigs
that come with the planer worked fine. It was an easier task than I thought.
Even torqued it to 50# as told in the manual.
I saw why i was getting ridges on my wood, they are a few fine nicks
that should be able to be sharpened out.
Oh yea, it said to be careful taking out old n putting in new blades; so you
don,t get cut. Well, the new blades had grease on them, I turned a blade
over n was wiping it with a paper towel....ouueeeeechhhh...got nicked. Not
to bad, but drawed blood. Leave the grease on, it not that much.
Anyway, thanks again........
Let the chips fall where they may................................


.

Relevant Pages

  • Re: Windscreen
    ... I've tried ways to get if off; neat screenwash, kitchen cleaner, ... Are you sure it is grease? ... New blades did not cure it until I fitted a complete new arm. ...
    (uk.rec.driving)
  • Re: Windscreen
    ... I've tried ways to get if off; neat screenwash, kitchen cleaner, window ... Are you sure it is grease? ... blades did not cure it until I fitted a complete new arm. ...
    (uk.rec.driving)
  • Re: Windscreen
    ... I've tried ways to get if off; neat screenwash, kitchen cleaner, window ... blades are in good condition. ... Are you sure it is grease? ...
    (uk.rec.driving)
  • Re: info
    ... Most problems can be fixed with grease in the beginning. ... find a sharp blade without nicks. ... But this one has got 3 blades with it. ... For plant material sledge-microtomes may be preferred under some ...
    (sci.techniques.microscopy)
  • Re: Sharpening Jointer Blades
    ... all the jigs. ... their jig is wide enough to do 12" planer blades ... so I don't have to send to send out anymore. ... I looked that up and found the cost too steep. ...
    (rec.woodworking)