Tablesaw - Router Extension

I am thinking of converting one of the sides of my Tablesaw into a router table. I see a lot of pictures of folks doing this, but I don't see the detail on how it's 'attached' to the TS. I have 4 bolts holding the current extension on the TS, but I don't know how I could use those bolts since the router extension would be solid, unlike the metal table top being 'hollow-like', if that makes any sense.

Could I just drill the holes into the side to hook to the TS then use a forstner bit to drill up through the bottom so that I have a place to start the bolts? Also, should the extension be bolted to the fence rails, too?

Any advice, links, pictures appreciated.

Mike
.

Relevant Pages

  • Re: Tablesaw - Router Extension
    ... I see a lot of pictures of folks doing this, ... I have 4 bolts holding the ... >since the router extension would be solid, unlike the metal table top being ...
    (rec.woodworking)
  • Re: Tablesaw - Router Extension
    ... I see a lot of pictures of folks doing this, ... I have 4 bolts holding the ... >since the router extension would be solid, unlike the metal table top being ...
    (rec.woodworking)
  • Re: Rate Adaptive?
    ... Had my router on an extension of the correct cable, ... next to the NTE5 and keeping the PSU at its cable length from the ... floors alongside the mains wiring between floors. ...
    (uk.telecom.broadband)
  • Re: torque wrench and extensions
    ... Using a steel extension, if you do not rest the extension on a beam, or get ... The current effect experienced some friction and there was some loss of heat, decreasing the voltage until equilibrium can be reached. ... torque wrench it'll probably be within 1 ft/lbs at the socket end. ... I'd use as short as an extension as possible for engine components, but in "the real world" where people reuse dirty head bolts and don't suffer immediate catastrophic failure, +-1% is probably good enough. ...
    (rec.autos.tech)
  • Re: Wiring question
    ... I propose to put a telephone extension in the back bedroom and set ... everything up, including the router, there. ... Rather than making up a cable we do suitable cables up to 20m! ...
    (comp.sys.acorn.networking)