Re: new saw -- talcum powder
- From: fredfighter@xxxxxxxxxxx
- Date: 3 Sep 2005 21:15:42 -0700
Mark & Juanita wrote:
> On Sun, 04 Sep 2005 02:19:58 GMT, "CW" <cmagers@xxxxxxxxxxxxx> wrote:
>
> >Caustic baby powder... Right.
> >
>
> I suspect that was not the OP's thoughts. The possibility that the baby
> talc may also be loaded with other hygroscopic ingredients (reasonable for
> where you are going to put baby powder) might be of concern.
>
Seesh!
Talcum powder is powdered talc, a soft rock primarily composed
of magnesium tetrasilicate. It protects iron from rusting via
electrowhateveritscalled protection, similar to galvanizing.
There is a nearly rust free iron column sitting in the middle
of a villiage soemwhere in India that evidently has been
protected by magnesium compounds in the soil and traces of
the same left on its surface from when it was cast for a
few hundred years now.
I've used talcum powder on a drill press, after four years
still no rust.
Any baby powder or other powder will have the ingredients on
the friggin' label. Just READ it for crying out loud. A
trace of fragrance won't hurt your saw.
Some (maybe most) BABY powders these days is cornstarch,
don't use those.
--
FF
.
- Follow-Ups:
- Re: new saw -- talcum powder
- From: WillR
- Re: new saw -- talcum powder
- References:
- new saw -- talcum powder
- From: Sam the Cat
- Re: new saw -- talcum powder
- From: CW
- Re: new saw -- talcum powder
- From: Mark & Juanita
- new saw -- talcum powder
- Prev by Date: cordless drill advice
- Next by Date: Buuild mobile bases for Drill Press
- Previous by thread: Re: new saw -- talcum powder
- Next by thread: Re: new saw -- talcum powder
- Index(es):
Relevant Pages
|
Loading