Re: Starboard footstrap insert fix

Roger,

Thanks for the prompt response. I've seen this stuff on the shelf, but
always considered it a half-ass fix for desperate times. However, if
RJ says it works, I'll give it a try.
The stripped screw was my fault - thick new strap, thick new strap
washer, pad foam wasn't yet compressed, and not enough downward
pressure for the first few turns of the screw. This stuff will
definitely go in the gear bag for Baja trip in five days...

Thx again and long time no see,

-Barry

On May 28, 10:31 am, "sailq...@xxxxxxxxxxxxxx"
<sailq...@xxxxxxxxxxxxxx> wrote:


Hi Barry,
There's a better, and much easier fix!
Check out this link on the Starboard forums:http://www.star-board.com/viewpage.php?page_id=21
Look down at the bottom of the page at "Repairing Damaged Footstrap
Inserts".
I've been able to repair a whole bunch of stripped footstrap screw
inserts and also vent plugs that are leaking
using these products, avaialable at your local auto parts or bearing
distributor's shops.
The inserts are continuous (AFAIK) so you could drill an adjcent hole
new hole (same size as the holes you've never
put a screw in) but the Permatex/Locktite Thread Restorer Kits do a
much better job with no risk of breaking out through
to the core of your board.
Hope this helps,
P.S. You should be able to view the link with out signing on, but the
sign on is easy and won't fill your mailbox or cause
any other probs that I'm aware of.
Customer service is still pretty important at Starboard!


.

Relevant Pages

  • Re: followup: 81 Scirocco craps < 2800 rpm
    ... and clamp both sides of the replaced hose. ... I did a fix using Seal-All and it seems there are no leaks. ... The plug in the hole over the screw was lost long ago, ...
    (rec.autos.makers.vw.watercooled)
  • Re: What to do with a playfield not holding screws?
    ... suggested thing to do to fix this, ... then tightening the screw back in the hole. ...
    (rec.games.pinball)
  • Re: Turning Point in History
    ... Is there an elongated hole there, ... as though it clamps onto the rectangular part with the screw. ... and the steady rest fit on the left flat ... make it for use without the riser block, ...
    (rec.crafts.metalworking)
  • Re: Best putty or epoxy for fixing stripped screw holes on PF (Quickwood?)
    ... Stripped screw hole repair. ... Turn the playfield so that the screw hole points up. ... Stick the blunt end of the skewer in the hole to be repaired. ... and it ended up pulling out & stripping out even more ...
    (rec.games.pinball)
  • Re: How to shrink heat shrink tubing?
    ... in and push the bread sensor rib and it would go down automatically. ... You only had to push it down at first. ... tight enough with one hand to put a screw in with the other. ... Finally I noticed a square hole next to each screw hole and realized a ...
    (sci.electronics.repair)