need help with old mitsubishi vs-5059


Can anyone point me to a site that details how to adjust the
convergence of the mistubishi vs-5059? yes, I bought it in '95 and
although i'm thinking about upgrading, it's still a great set except
for the convergence problem I have. The pincushion has never been
adequate enough to adjust it by; i've always had to take it to a
service place.

Thanks.

.

Relevant Pages

  • Re: Hitachi C10FL Tablesaw, Any Good?
    ... I have the C10FL and it is a decent saw for the money but has a few ... I bought a Forrest blade for it and it cuts great. ... I'm pretty happy with it for the money. ... All controls were right up front, no leaning around the side to adjust ...
    (rec.woodworking)
  • Re: Toshiba Rear Projection Convergence board problem
    ... Don't adjust the convergence until you repair the convergence ... The resistor is propably blown again. ... > problem with the convergence board. ...
    (sci.electronics.repair)
  • Re: Definitive guide to convergence
    ... I have to adjust convergence on my Tempest ... > Matt, I have a four-page color document from Video Display Corporation ... > of the tube, ...
    (rec.games.video.arcade.collecting)
  • [tip:timers/ntp] ntp: adjust SHIFT_PLL to improve NTP convergence
    ... ntp: adjust SHIFT_PLL to improve NTP convergence ... The conversion to the ntpv4 reference model ... causing NTP convergence time to greatly increase. ... * adjust the frequency correction for a given offset in PLL mode. ...
    (Linux-Kernel)
  • [GIT pull] ntp updates for 2.6.31
    ... ntp: adjust SHIFT_PLL to improve NTP convergence ... * for a slightly underdamped convergence characteristic. ... * adjust the frequency correction for a given offset in PLL mode. ... * convergence time, but making the clock more stable. ...
    (Linux-Kernel)