Re: Seat twist problem


oh. one more thing to try. take an old biek tube and cut a little piece
from that and use it to shim up the space involved. even a thin piece
of rubber that doesn't go all the way around the seatpost should be
more than enough.


--
markf

stuck in iowa and unemployed.
------------------------------------------------------------------------
markf's Profile: http://www.unicyclist.com/profile/8102
View this thread: http://www.unicyclist.com/thread/45378

.

Relevant Pages

  • Re: Drive Train Alignment Question
    ... it is a Carolina Customs frame. ... Aluminum won't rust but it will corrode and gray. ... if it was *me* - I would match the shim profile to the mounting point ...
    (rec.motorcycles.harley)
  • Re: Whats that Yellow Thing in My Bedford?
    ... that's a shim i used them with my KH prototype frame (for sale people) ... to use my 42MM bearings (profile) not exsactly the same so they needed ...
    (rec.sport.unicycling)
  • Re: Nimbus/ kh moment cranks
    ... frame takes 25.4mm seatposts. ... Or he could buy a shim. ... 'deviantART' ... Borgschulze's Profile: http://www.unicyclist.com/profile/13501 ...
    (rec.sport.unicycling)
  • Re: Homemade Carbide Lathe Toolholder
    ... between the shim and the steel tool ... holder. ... Prev by Date: ...
    (rec.crafts.metalworking)
  • Problem - loose cone/cup.
    ... old french frame (LeJeune, ... I could shim or loctite the new one, ... Prev by Date: ...
    (rec.bicycles.tech)
Loading