Re: Scratchy RF gain knob on 535D



In article <XISgj.60938$rc2.20230@xxxxxxxxxxxxxxxxxxxxxx>,
mc <look@xxxxxxxxxxxxxxxxxxxxxxxxxx> wrote:
"David" <nothere@xxxxxxxxxxx> wrote in message
news:13o7rd1anqe7743@xxxxxxxxxxxxxxxxxxxxx
labtech_one wrote:
You can use contact cleaner, or just plain ole WD40, spray and work
the control back and forth a few times to break loose the
'dirt' and then spray again to rinse it away. Wait about 1 hour,
for the spray to dry, before using the radio again. WD and some
contact cleaners are a) flamable and/or b) conductive

If the problem is good contact between the metal wiper and the carbon
or plastic resistive element, a little conductivity might not be a bad
thing.

I strongly recommend using the appropriate Caig product (available at Radio
Shack) rather than WD-40 or a solvent chosen at random. That will help
ensure that it stays clean and properly lubricated after the cleaner dries.

From the directions on their web site, "CaiLube MCL". I found it at the
local Fry's. MG Chemical's "Nu-Trol" works about the same. Lubricating
control cleaner seems to be the generic name.

I reserve the De-Oxit type stuff for cassette tape unit "Record"
switches, leaky battery holder terminals, VCR Mode Switches,
intermittent phone jack cutout switches, and the like where the
problem is cruddy metal-metal contacts.

Mark Zenier mzenier@xxxxxxxxxx
Googleproofaddress(account:mzenier provider:eskimo domain:com)


.



Relevant Pages

  • Re: Scratchy RF gain knob on 535D
    ... for the spray to dry, ... That will help ensure that it stays clean and properly lubricated after the cleaner dries. ... It's unlikely to happen in an RF gain control. ... We've never waited an hour to avoid explosions from the De-Ox-It or the WD-40. ...
    (rec.radio.shortwave)
  • Re: Scratchy RF gain knob on 535D
    ... for the spray to dry, ... ensure that it stays clean and properly lubricated after the cleaner dries. ... RF gain control. ... around the knob. ...
    (rec.radio.shortwave)
  • Re: Scratchy RF gain knob on 535D
    ... for the spray to dry, ... ensure that it stays clean and properly lubricated after the cleaner dries. ... RF gain control. ... Thanks to all the responses. ...
    (rec.radio.shortwave)
  • Re: Scratchy RF gain knob on 535D
    ... for the spray to dry, ... I strongly recommend using the appropriate Caig product (available at Radio ... RF gain control. ... or regular old control cleaner instead. ...
    (rec.radio.shortwave)
  • Re: Apollo One, the FBI, and Scott Grissom
    ... > controller 360 degrees clockwise and switches thrust vector control ... THIS SWITCHES FROM THE APOLLO GUIDANCE COMPUTER TO MANUAL ... > electrical failure an auto abort will continue. ... Scott Hedrick's still waiting to know who ...
    (sci.space.history)

Loading