Re: Question regarding External Speaker hook-up


Telamon wrote:

>
> I don't understand why you had to "float" the connection from the Drake
> SW8 to the Alpha Delta VRC because I don't know what it is. Maybe it was
> an active speaker?

Now discontinued VRC, external speaker w/audio filtration (notch, peak,
high freq cut-off, low freq boost/cut-off):
http://www.alphadeltacom.com/pg12.htm

Warning in instruction manual that "if neither radio receiver output
lead is grounded to the radio chassis, e.g. an insulated jack or
balanced output, then DO NOT connect the body of the plug to either
output terminal as this may cause damage to the circuits of the radio
but instead connect the tip of the plug to one of the output terminals
and the body of the plug to the radio receiver chassis. If the radio
otput is an insluated 1/4'' jack as with the Drake SW8, use the
furnished plug adapter and connect the wire lead of the adapter to a
screw on the radio chassis. On other radios with balanced output, make
or buy an adapter to make these connections properly."

As stated by someone previously in this newsgroup: "Be very careful
when connecting Drake radios to active devices like computer speakers
and applifiers. Some sets, the R8 series excluded, have a floating
output, and if one leg is taken to ground by the following device, it
will fry the ouput of the Drake."

So basically, I'm just seeking to make sure that the instruction
manual's caution is not applicable to the following said radios:
'2010, 'SW77, E1

>
> If you are connecting the radio to an external passive speaker you just
> have an external isolated voice coil in the speaker and so you just
> connect the two wires from the radio using the appropriate plug. Most
> speakers are 4 to 8 ohms impedance and most tabletop to large portable
> radios have enough power to drive a bookshelf size speaker.

It's not a passive speaker. Sorry, I should have specified.

>Headphones
> are a better candidate for a small portable.
>

Yes, I agree by and large; that's why I've never bothered to hook these
up to an external speaker. The filter options on the VRC are pretty
decent, though. Since I've recently taken this speaker out to use with
an R8B, I thought why not give it a go with some other radios.

junius

.

Relevant Pages

  • Fitting co-ax aerial socket to DAB radio that doesnt have one
    ... I recently bought a Sony CMT-SPZ90DAB mini hi-fi with a DAB radio. ... a small plastic 3 pin plug which fits into a 3 male pin socket. ... "slim jim" DAB aerial with 75 ohm co-ax and no way of connecting either ... Connecting to the single pin or the aerial wire, ...
    (sci.electronics.basics)
  • Re: Balun Hook-Up and Signal Images - What is the Connection ?
    ... So by itself the Radio using the built-in Whip Antenna ... Questions - The Basic Wire Antenna: ... - How are you connecting the External Wire Antenna to the Radio? ...
    (rec.radio.shortwave)
  • Re: Radio problem Omega Elite
    ... I am thinking that becaus the car had no radio when I bought it, ... It was strange that by connecting one output wire ... >> there must be some type of ampbetween the speaker output and speakers ... This means that by randomly connecting speaker wires to ...
    (uk.rec.cars.maintenance)
  • Re: Muting car stereo without damage?
    ... switch is used in the speaker wires will it harm the radio to have the ... Should not have any problem disconnecting the speaker wires ... connecting the load will only let whatever current its ...
    (sci.electronics.basics)
  • Re: CW connector
    ... standard or most prevalent kind for connecting a CW key to a radio? ... A few use a phono plug. ... A lot of recent equipment has an 1/8" stereo jack that allows you to ...
    (rec.radio.amateur.homebrew)