Re: Simplified G2 Regulator for a 4CX250B amplifier

What are you trying to do?


TR1 looks like a current limiter for the FET. Why are you doing that?

The source voltage looks like 425 volts, the series resistor 10k 2W,
the shunt regulator threshold 340-350 volts.

that's about 75 volts differential, so the 10k would have about 7.5 mA
of current. If the screen loaded more than 7mA it would fall out of
regulation.

The FET dissipation would be 2.5 watts assuming no negative screen
current.

What holds the screen to ground when the overload opens?

Why is the VDR on the screen side of the screen current meter?

Maximum screen dissipation would be around 21 mA when the screen was at
about 200 volts. Maximum screen current about 40mA.

73 Tom

.

Relevant Pages

  • Re: 500V DC Source and femtoamp resolution
    ... The FET itself is regulated by control circuitry that is powered by ... Thus, to regulate 100 volts, the control circuitry will rise itself 100 ...
    (sci.electronics.design)
  • Re: Looking for dual FET (I think...)
    ... I am looking for a replacement for what I believe is a dual FET. ... specs for this device so that I could fine a suitable replacement. ... I had a similsr problem with a B&K analog FET meter, ... to 1.35 volts across leads on hi and 0.33 volts on Lo. ...
    (sci.electronics.repair)
  • Re: need 24V to 115VAC 3 phase inverter for gyro
    ... volts DC with a high frequency DC to DC converter then use a counter to generate the three phases which drive a six FET three phase H bridge to generate a modified sine wave using the 180 volts DC that you generated with the HF transformer which is much lighter weight than a 400 Hz transformer for the same wattage. ...
    (rec.aviation.homebuilt)
  • Re: Boost Converter / LT SPICE
    ... not produce 5 volts for input lower than 16 volts. ... I am using FET ... when the input voltage is between the range of 1.6 volts to 5 volts. ... The data sheet says other wise. ...
    (sci.electronics.design)