The Great Strip-X Substitute Hunt, Part 2

Not too long ago, I inquired about a substitute for General Cement
"Strip-X", an old stand-by on quick removal of the enamel of "coil
wire." It was a smelly, blackish gel, came in a small bottle, and
wonderful for stripping off coil wire enamel in a minute or two.
It isn't made for the electronics hobby trade anymore, but there
IS a reasonable substitute: Jasco 0201 Premium Paint Stripper,
available at most Lowe's, Home Depot, OSH, True Value chain
stores, about $4.75 for a pint.

I have some toroid coils under construction, all using #32 and #34
AWG enameled coil wire. A #$%^!!! to strip those with either
single-edge razor blades or fine-grit finishing paper. With the
Jasco stripper gel, two dips and a WAIT of about 15 minutes will
allow a wiping cloth to remove the enamel without damaging the
wire. A lot longer wait than with Strip-X, but it is better than
nothing.

The same Jasco paint stripper will also loosen the lithographic
designs/labels on small tin cans. [see other post] The newer
can paints are tougher than those of 30+ years ago so it might
be necessary to use some steel wool to help remove the paint
(with the gel still on it). Doesn't appear to affect the steel
wool.

The product contains methylene chloride (said to be a toxic
substance, especially to Californians and their overly-strict
hazardous materials rules). Another brand and product at Do-It
Centers had that plus formic acid; didn't get that, a bigger
can and it cost about $18. Whatever was in old Strip-X must
have been stronger and nastier. [my last bottle dissolved the
bristles of the bottle cap brush after sitting for a few years]

So far, the hobby room's production line has been humming along
without breaking any fine coil wire in order to solder to the
toroid winding's ends.

LenAnderson@xxxxxxxx

.

Relevant Pages

  • Re: TESLA COIL ~ First Fire-Up
    ... for the bottle capacitor had two wires running down inside the bottle ... He's re-doing the bottle capacitor with only a single ... We did shave the coating off the magnet wire. ... >with the toroid before it goes to school. ...
    (sci.electronics.basics)
  • TESLA COIL ~ First Fire-Up
    ... We built our caps using the salt water/beer bottle trick. ... We never got any streamers. ... sparking between the magnet wire and the connection to to toroid. ...
    (sci.electronics.basics)
  • Re: Bottle dynamo front fork mount/bracket
    ... I'm trying to fit a bottle dynamo to it's front fork but it's ... Just attach the earthing wire from the lamp to the mount somehow - ...
    (rec.bicycles.tech)
  • Re: Jobo ATL-2300 chemical pumping error
    ... the wire was free of corrosion/debris. ... the 2 blue wires proved more problematic. ... the pump activated once more and the bottle was emptied. ... that I can try to get inside the manifold to look at the lower sensor ...
    (rec.photo.darkroom)
  • Re: Stripping 40 AWG/45 SWG or finer magnet wire/enamelled copper wire?
    ... :>:To then be able to solder to coarser wire. ... :>:I tend to grip between 2 fingertips and abraid with the finest grade of ... Use a rapid paint stripper - it works ... :I tried some ordinary "slow" paint stripper, ...
    (sci.electronics.repair)