HP8753A help required
- From: David <dhuisman@xxxxxxxxxxxxxx>
- Date: Fri, 13 Jul 2007 10:36:16 GMT
Hi,
I have just purchased a HP8753A VNA and need some help setting the thing up.
I want to start off just measuring impedance of lumped components but I cannot get any sensible readings. I have tried all sorts of Calibrations from the operation manual but still no luck.
I have the HP85044A Test Set and the 50 Ohm Calibration set.
I am trying to connect a coaxial lead to the Test port on the Test Set and so a 1 Port measurement. I have tried both RESPONSE cal and 1-Port Cal and placed a short,oopen and 50 Ohm load at end of the coax and then after calibration I place a leaded cap but do not get anything like I see in RF books I Have.
Any help much appreciated.
Regards
David
.
- Prev by Date: Re: Filters to get rid of inverter noise
- Next by Date: WTB - Desk Mic for IC-718
- Previous by thread: Filters to get rid of inverter noise
- Next by thread: WTB - Desk Mic for IC-718
- Index(es):
Relevant Pages
|
