tube-noob question

In a circuit with two 6.3V tubes, can I just series the filaments so
that I can use a 12-13.8V supply? Or are there subtleties that I'm
missing?
Thanks,
Ross NS7F

.

Relevant Pages

  • Re: 7.2 volt to 6.3 volt ?
    ... the tubes are used in a RF circuit. ... There is no RF on the filaments but only on the plate caps. ...
    (sci.electronics.repair)
  • Re: More cap tuning
    ... The two tubes are amplifying the same ... flow, while idle, allows perfect silence to be output to the speaker, ... pass signals. ... I learned of this circuit from John Broskie's www.tubecad.com site. ...
    (rec.audio.tubes)
  • Combination class A/AB Switch and post-PI Master Volume circuit idea - comments?
    ... I show a typical connection of phase inverter to output stage, ... using a stereo pot to cut both phases equally, or using a pot wired as ... I've tried the rheostat circuit, ... I'm putting tubes into an old solid-state Univox combo that sounds ...
    (alt.guitar.amps)
  • Re: conservatives rework bible
    ... enriched this group when s/he ... Is the circuit short? ... Old tubes must be a problem. ... I agree with you about the sound. ...
    (talk.origins)
  • Re: 211 and 845 operating Ea/Ia bias points.
    ... Anthony's suggestion (different tubes, different values, different ... I'd be interested to hear more details on the silicon pseudo choke. ... I'm sure you know how to make a CCS but if you, or anyone else, don't ... A great circuit component if you're more interested in music ...
    (rec.audio.tubes)