Re: Spectrum analyzers

On Tue, 23 Sep 2008 11:01:53 -0700 (PDT), Art Unwin
<ArthurUnwin@xxxxxxxxx> wrote:

I would really like something smaller or say
modify something like a audio setup as a project.

Audio spectrum analyzer (free):
<http://www.sillanumsoft.org>
I use this one on my laptop for audio generating and testing. Try to
get a 96Khz sound card or dongle as the typical internal laptop sound
card is really marginal. No RF, no antenas, but good for audio.

Look into SDR (software defined radio) projects. Most of them will
also act as a spectrum analyzer. For covering bands above 30MHz, use
a mixer and a signal generator:
<http://www.rfspace.com/SDR-14.html>
I really don't know much about these but they look interesting.

Now, if you have a sizeable bank account, one of the various Anritsu
hand held spectrum analyzers are really nice:
<http://www.us.anritsu.com/products/ARO/North/Eng/Spectrum-Analyzers.aspx?lc=Eng&cc=US&rc=ARO&cat=1&cat2=2&cat3=5&cat4=0>

There are also a large number of hand-help CATV spectrum analyzer
available if you want portability. I've only played with a few, so I
can't offer any useful recommendations. They usually don't have
sufficient resolution to seperate HF stations.

Incidentally, in order to use a spectrum analyzer for antenna testing,
you'll need a directional coupler (or VSWR bridge) and an RF sweep
generator.

--
Jeff Liebermann jeffl@xxxxxxxxxx
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558
.

Relevant Pages

  • Re: Measuring filter shape factor
    ... >>>3) RF generator connector to antenna input ... >>>and measure the audio level from the distortion analyser. ... This was a crystal filter, so you will need a RF generator ... You need the distortion analyzer to ...
    (rec.radio.shortwave)
  • Re: Sinclair Duplexer Retuning
    ... analyzer with a tracking generator. ... connected to the cavities and a spectrum analyzer on the other end. ... monitor with a sweeping generator & a spectrum analyzer ...
    (rec.radio.amateur.misc)
  • Re: ampex 440 record alignment
    ... scope mainframe from about the 70's to early 80's on back to the late 60's and buy a spectrum analyzer plug in, probably all for under $500 total. ... digital audio approach to align an analog tape machine, but for one-time or few-times use it could work well, and for not much money. ... A good on-board sound card on a new PC has all the bandwidth, frequency response 50-15KHz, low distortion and low noise that you need to front-end the software. ...
    (rec.audio.pro)
  • Re: ampex 440 record alignment
    ... and buy a spectrum analyzer plug in, probably all for under $500 total. ... digital audio approach to align an analog tape machine, ... low distortion and low noise that you need to front-end ... A cheap DVM could be your calibration standard for test tones ...
    (rec.audio.pro)
  • Re: Measuring filter shape factor
    ... input to audio output. ... FFT analysis is only used when you need speed. ... >>3) RF generator connector to antenna input ... You need the distortion analyzer to ...
    (rec.radio.shortwave)