Re:Tennamast cage, how to elongate the holes
Hi
Just purchased a Tennamast cage and the holes don't match that of the bolts
on my rotator. Trust mine to be different
What is the best method to elongate the hole that are already there?
73 Andy
.
Relevant Pages
- Re: OT mailbox post?
... About a four-foot length of Well Casing or 4" square extra-heavy ... doesn't bend while the bolts are shearing. ... the middle of the plate into the tubing for the restricting device. ... The bottom plate for the footer is 16" square by 1/2" HRS with holes ...
(rec.crafts.metalworking) - American Tower parts - Be prepared for GRIEF
... I bought some new parts for my Rohn 25 from OldTowerGuy on Ebay, ... I got bolts into holes on two legs, ... They were too far into the leg ...
(rec.radio.amateur.antenna) - Re: Taking apart and rebuilding
... Using screws or lag bolts would be ideal but after a few times I'm ... sure I'll have to redrill new holes. ... it's a pain for a few reasons. ... the wing nut will tear up the ...
(rec.woodworking) - Re: How to Drill Out a Broken Bolt?
... the other two broken bolts using the Dremel tool. ... the way to drill out the broken bolts. ... I found that the holes pretty much losed ...
(rec.boats) - Re: towbar fitting
... After fitting my first towbar myself, and later watching it being done ... on another car in a commercial garage, I would *never* let anyone else ... The *professional* simply put the bolts through the holes drilled ...
(uk.rec.caravanning) |
|
