Re:Homebrew traps

What sort of capacitors can I use in parallel in making some 7MHz and
3.7MHz wire wound traps?

What voltage should they be and is the value that important?

Max power will be 200 watts.

Thanks


.

Relevant Pages

  • Re: FX-6A flashtube availability and data
    ... all but the one designated as the sparker are used only as ... One clue is that the max anode voltage is 1,000 volts. ... an internal trigger takes less than the full holdoff voltage. ... I recall that the flash capacitors are charged to 600 volts; ...
    (rec.crafts.metalworking)
  • Re: B+ rectifier question
    ... I replaced all the electrolytic capacitors. ... diodes mounted on a strip and I replaced the original 2 diodes for the B+. ... I have to run the preamp on a variac at 110v because the filament voltage ... Do you recommend for the B+ using resistance before the ...
    (rec.audio.tubes)
  • Re: 9.5 questions on capacitor, LED, resistor
    ... Does output voltage stay ... LEDs require a resistor, but how do you calculate the required ... There are three limits on all components: voltage, current and power. ... Almost all capacitors are rated for some sort of overvoltage; ...
    (sci.electronics.basics)
  • Re: Tantalum cap failures
    ... Normal opperating supply voltage in our application is 28V. ... >We have had problems with some capacitors becoming short circuit during ... >The bank of caps is there to sink/source short-term PWM current ... >Total steady-state ripple current is around 0.5A. ...
    (sci.electronics.design)
  • Re: SOLA Constant Voltage Transformer
    ... I'm sort of hoping to use it as an isolation transformer for my ... line voltage in. ... I don't understand why a ferroresonant transformer / capacitor combination, ... I wouldn't have expected his scanner to be that fussed about ...
    (sci.electronics.repair)